Simple Steps to Replace Your Square Toilet Seat

Even under the most ideal conditions, achieving perfection in bathrooms can be difficult. However, small bathrooms pose an additional challenge. When space is limited, it becomes even more crucial to meticulously design and plan every aspect. Both round and square toilet seat comes with their unique advantages. Do you have a square toilet and you want to replace its seat? You can do it anytime you want. But you have to select the right square-shaped toilet seat before starting the project!

Safety Measures to Follow Before Replacing Toilet Seat

it is crucial to acknowledge that toilets harbour harmful bacteria. You should know it before replacing the square toilet seat replacement. Being exposed to these microorganisms can result in severe sickness and infections. Hence, it is imperative to take the required safety measures before commencing the task. Put on rubber gloves before cleaning the toilet with an anti-bacterial spray. These precautionary steps encompass wearing rubber gloves and thoroughly sanitizing the toilet using an anti-bacterial spray.

Have these few tools ready for an easy process to replace a squire toilet seat replacement:

• New square toilet seat
• Tape measure to confirm the correct size
• Flathead screwdriver to remove old seat bolts
• Pliers or adjustable wrench to loosen stuck bolts
• Spray lubricant or soapy water to ease removal
• Replacement bolt sets for the new seat

How to Replace a Toilet Seat

Remove the Old Toilet Seat

The humid yet poorly ventilated environment inside a bathroom can quickly corrode the metal bolts fastening the toilet seat to the bowl. Fortunately, some models use plastic bolts, which simplify seat removal. The difficulty of detaching an old square toilet seat depends on whether it was installed with plastic or metal hardware.

To begin removing the seat, pry off any bolt caps on the seat's inner edge where it attaches to the bowl. If there are no caps, proceed to the next step. Use an adjustable wrench to loosen the two nuts on each side of the toilet. Turn them counterclockwise. Remove the bolts at the bottom of the hinges by manually turning them until they detach. Take off any washers too.

If the bolts are rusty, (which is common) spray them with a lubricant and let sit briefly before unscrewing. For stubborn plastic bolts, apply soapy water before removing them. Once the hardware is detached, dispose of the old seat.

Clean the Toilet Bowl

Thoroughly clean the toilet bowl after removing the old toilet seat! Keep focusing on the area around the bolts. It will be inaccessible once the new seat is installed. Use an anti-bacterial spray and wipe the surface dry with wipes. Please refrain from flushing the wipes down the toilet. Instead, kindly dispose of them in the trash.

Fit the New Toilet Seat

First, unpack the new toilet seat and place it properly on the toilet bowl, making sure the hinges align with the old seat's hinge points. Proper alignment allows for easy bolt insertion.

Next, insert the two bolts through the hinge holes with the bolt heads facing up to prevent slipping. Add a nut to each bolt and turn clockwise to tighten. The bolt ends will stick up through the toilet bowl. Use an adjustable wrench to fully tighten both nuts.

Premium square-shaped toilet seats may have self-locking nuts instead of bolts for easy snap-on installation. Always refer to the user manual and follow all instructions when installing a new toilet seat model. Finally, if the seat has plastic bolt caps, gently press them onto the bolt heads to snap them into place.

Following some easy steps you could successfully replace the toilet seat. Wash your hands and you are ready to use the square-shaped toilet seat.